The Custom LED "Magic Blinker"
is designed to allow single filament light bulbs, single intensity LED
assemblies, or any two-wire indicators to function as both running lights AND
blinkers - at full brightness! Simply connect your single filament bulb or LED
to the Custom LED Magic Blinker and your indicator bulbs/LEDs will now stay on
constantly as running lights, and blink when you engage the blinkers!
(Note:
the indicator will turn off for the duration of the blinker pulse - this is how
the blinking is achieved.)
The Custom LED Magic Blinkers
are designed to be as small as possible while being as versatile and robust as
possible. The finished dimensions of the unit will measure approximately 0.7" x
1.25" X 0.25" and can carry up to 5A (~65W) of current! This ensures our product
will work for any application (blinking your headlights individually, or
powering one single LED signal for instance).
To further ease installation
and ensure dependability, the Custom LED Magic Blinkers are entirely water
resistant.
The Magic Blinkers are
applicable for any and all situations where a single filament lamp, or single
brightness LED or LED cluster is desired to function as both a running light and
a blinker light.
The Magic Blinkers come with
7" leads, all required electrical connectors and detailed installation
instructions!
NOTE: THE NEW AND IMPROVED MAGIC BLINKER IS COMPATIBLE WITH ALL FLASHER RELAYS.
TYPICAL
INSTALLATION DIAGRAM
GENERAL NOTE: For
motorcycles that do not have running lights in the front of their motorcycle
(such as the new Kawasaki sportbikes), the red wire on the magic blinker must be
connected to an ignition switched source for proper operation. The headlight
source is perfect for this.
HONDA BLINKER SYSTEM SPECIAL NOTE: In order to properly utilize the Custom LED Magic Blinkers on the Honda
CBR 1000RR, years 2004 and newer, (as well as numerous other Honda motorcycle
models) the constant power input wire (red) must be connected to a ignition
switched source (other than that for the stock blinkers). The headlight source
is perfect for this. The problem is that the running light wire that runs to the
blinkers cuts off when the blinkers are activated, and stays off until the
blinkers are canceled. This causes the operated load (LEDs or lamps) to not work
properly as the Magic Blinkers are designed to draw all power from the "running
light" input wire.
Using a voltmeter, you can
easily verify if you are having this problem. Simply measure the voltage on the
RED input wire on the Magic Blinker to check for constant 12V power - blinkers
on or off.
Magic Blinkers installation instructions (requires
Adobe Reader to open)
